Windows cannot be booted from a controller card.
The hard drive must have Windows reinstalled because a new controller card was installed.
The SATA controller card was not set as a boot device in the computer BIOS.
The new controller must have the correct jumper settings for Windows mode.
第1题：
A.
B.
C.
D.
第2题：
A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）
第3题：
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller.Which of the following is the MOST likely cause of the problem?（）
A. Both hard drives have the master jumper in place.
B. One hard drive is set as master and the other slave.
C. The hard drive data cable is reversed.
D. Both hard drives have the cable select jumper in place.
第4题：
An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）
第5题：
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller. Which of the following is the MOST likely cause of the problem?（）
第6题：
A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）
第7题：
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）
第8题：
A. Hard disk drive failure
B. NTLDR file is missing
C. BIOS is corrupted
D. System board failure
第9题：
A technician purchases a new 120 GB IDE hard disk to use in an old server as a swap drive. After adding the drive to the server， the technician discovers that the operating system does not detect the drive. After rebooting the server， the technician notices the drive is missing from POST and comes to the conclusion that the BIOS needs to be updated. The technician downloads the latest version of the BIOS update from the manufacturer website. Which action should the technician take next？（）
第10题：
In which of the following locations would a technician set the LBA mode for a hard drive？（）