After installing a second processor and corresponding heatsink into a server, an administrator notices that the new processor is not showing up during POST.  Which of the following could be the cause of this issue?()A、 The power supply is not sufficient t

题目

After installing a second processor and corresponding heatsink into a server, an administrator notices that the new processor is not showing up during POST.  Which of the following could be the cause of this issue?()

  • A、 The power supply is not sufficient to power the server.
  • B、 The voltage regulator module (VRM) was not installed.
  • C、 The IRQ setting was not set.
  • D、 The DMA setting was not set.
如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

An administrator will replace five current servers. Which of the following is the MOST important to review before installing new servers?()

A. Verify uninterruptible power supply (UPS) load

B. Verify if server consumes 220V

C. Verify CPU load

D. Verify if server consumes 110V


参考答案:C

第2题:

Several reports are logged stating that an application server is performing slowly. During the investigation, the administrator notices that the hard drives on the server appear to have a high level ofactivity.  Which items should the administrator monitor using performance monitoring tools? ()

  • A、 Page File
  • B、 Disk Utilization
  • C、 System Temperature
  • D、 Processor Utilization
  • E、 Network Utilization

正确答案:A,B

第3题:

A user reports it takes a long time to load all applications and the hard drive LED is showing constant activity. Which of the following is MOST likely the issue?()

A. The processor is faulty.

B. The file system is fragmented.

C. The modem drivers are corrupt.

D. The power supply is faulty.


参考答案:B

第4题:

The technician has replaced a power supply with an identical power supply, and now the high end graphics card is not working. Which of the following should the technician check?()

  • A、The memory
  • B、The CMOS battery
  • C、The PCIe power jack
  • D、The processor for chip creep

正确答案:C

第5题:

A technician is building a Windows 2008 server and has installed a motherboard, processor, and power supply. Which of the following optical drives should the technician install?()

  • A、Flash Drive
  • B、DVD-RW
  • C、CD-ROM
  • D、SSD

正确答案:B

第6题:

An administrator identifies that a server is shutting down. The administrator powers up the server and OS loads but after a few minutes it powers down again. Which of the following is the cause?()

  • A、Redundant power supply failure
  • B、CPU overheating
  • C、Memory failure
  • D、Hard disk failure

正确答案:B

第7题:

An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem?()

  • A、The hard drives were not plugged into the server correctly.
  • B、The controller driver is outdated and needs to be updated from the OEMs website.
  • C、The firmware for the server is too old and does not support the new RAID controller card.
  • D、The cable from the controller to the hard drive backplane is not connected.

正确答案:C

第8题:

An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?()

A. Processor failure

B. Third party memory

C. Disk drive failure

D. ESD during the upgrade

E. Backplane failure


参考答案:B, D

第9题:

Which of the following is the MOST likely to cause a server power supply fan to fail but allows the power supply to still be functional?()

  • A、Dust
  • B、Power Surge
  • C、Excessive humidity
  • D、High temperatures

正确答案:A

第10题:

A user reports it takes a long time to load all applications and the hard drive LED is showing constant activity. Which of the following is MOST likely the issue?()

  • A、The processor is faulty.
  • B、The file system is fragmented.
  • C、The modem drivers are corrupt.
  • D、The power supply is faulty.

正确答案:B

更多相关问题