An administrator reboots a ten drive server， with a RAID 10 

第1题：

An administrator buys a new server. The server has four disks and needs to be configured formaximum space. Fault tolerance is not a constraint. Which of the following configurations completes this task？（）

• A、RAID 0
• B、RAID 1
• C、RAID 5
• D、RAID 10

第2题：

An administrator needs the fastest read/write capabilities with the most redundancy， cost is not afactor. The current data requirement is 750GB but will double in the next year. Which of the following BEST meets these requirements？ （）

• A、 Use RAID 1 with ten 300GB hard drives.
• B、 Use RAID 6 with seven 300GB hard drives.
• C、 Use RAID 5 with six 300GB hard drives.
• D、 Use RAID 10 with ten 300GB hard drives.

第3题：

第4题：

A server has had a drive fail in its storage RAID set.  The administrator swaps the drive with a replacement and the RAID set does not automatically start to rebuild the replaced drive.  Which ofthe following utilities would MOST likely be used to initialize the rebuilding of the replace mentdrive？（）

• A、Net use
• B、Array management
• C、Fdisk
• D、Disk Management Plug-in

第5题：

A server contains a 3 disk RAID 5 array. The red LED is illuminated on one of the drives. Which of the following should the server administrator perform？（）

• A、Replace the drive
• B、Restore the drive from backup
• C、Reboot the server
• D、Reconfigure RAID 5 to RAID 10

第6题：

An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. Theadministrator powers up the server， during POST the RAID controller is recognized but none of the drivelights flash.  Which of the following should the administrator do FIRST to trouble shoot the problem？（）

• A、 Check the backplane cabling.
• B、 Check the server BIOS.
• C、 Update the RAID controller firmware.
• D、 Install the latest hard drive firmware.

第7题：

An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）

• A、The hard drives were not plugged into the server correctly.
• B、The controller driver is outdated and needs to be updated from the OEMs website.
• C、The firmware for the server is too old and does not support the new RAID controller card.
• D、The cable from the controller to the hard drive backplane is not connected.

第8题：

第9题：

A system administrator needs to maintain 1.2TB of storage for a database server. There are six 250GB drives available in the server for storage space. Which of the following RAID configurations would be the BEST choice given that performance and fault tolerance are important factors?（）

• A、RAID 1 across drive pairs totaling 3 pairs
• B、RAID 5 across all 6 drives
• C、RAID 10 across all 6 drives
• D、RAID 0 across all 6 drives

第10题：

An administrator has added a new hard drive to a server that is running out of space on its C Drive and is experiencing slow performance.  The administrator needs to free up space on the C Drive.Which of the following is the BEST action for the administrator to take to free up space on the drive？（）

• A、Move the page file to the new drive.
• B、Copy the system32 directory to the new drive.
• C、Convert the C drive to a basic disk.
• D、Setup a software RAID to mirror the C drive.